Hi,
This gets boring for some but reshapeing is simply finding a well suited shape off valve (head) that will flow highest cmf of air for a given pressure drop, Imagine you connect you vacume cleaner to the combustion chamber and that when sucking it draws air through the intake valve port only ( only imaging it). ok If this was done with the valve removed this would probalay flow a given figure at max.
Now if the valve was replaced and opened 1 mm off the seat the flow would be a lot less, you agree? As you do this at different amounts off valve lift you would be able to plot a graft ,Yes. Now go back to the valve only 1mm off its seat, what can be done to increase the air flow at this amout off lift? Sharp corners impede air flow so a gentle angle applied to the valve and seat would greatly aid air flow at low lift YES. and a Valve spends more time at low lift then at fully open so if you can increase airflow, you now see more bang inside the cyclinder and power at the wheels.
Valve seat widths and port angles also increase flow into the cyclinders but the valve to valve seat has the most room for increase in airflow/power
I have a standard valve reshaped in the garage and will try to post a picture to show a good shape for increased power