MOT pass today on the 126

after a fail yesterday

Went to my very strict but fair garage where they are into old cars. I thought I felt a bit of a brake pull when I drove the car on Sunday then again a hint of on the way to the MOT. On the brake test machine the near side was working at one sixth of the off side. Other fail item was the lack of a boot on the nearside ball joint. The boot thing was interesting as they have a steel collar on them so whilst they can rot they can not fall off completely so at some stage that boot had been just left off.
Said to the MOT man "you missed that one when you did the MOT last year"
answer "they only added it to the MOT test about 6 months ago!"
The brake cylinder had one seized piston and the other one piston leaked along with quite worn brake shoes. So sorted all that then had a hell of a job getting the brake fluid to run through for bleeding, I must have pumped that pedal over 100 times with the bleed nipple completely removed before any fluid came through. The brake drum was a bit grooved so I knew that the shoes would take a little bedding in. So back at the garage which is about a 12 mile run & the brake pulled up straight. On the brake tester the near side was still well down but the guy knew the situation and being a good old boy he used the power of the rollers to keep the nearside wheel turning while he kept the brakes on, release, then on again. After about 3 minutes the result was that the braking power came up to almost the same as the offside. Still a little bedding in to go but MOT pass
