I found that my ring was a bit loose (

), presumably this is the trigger as it rotates on the dizzy, is it important that this is held in place? Any suggestions as to how this could be done? (I did think of using araldite but i think it would melt as it seems to get quite hot in there..)
I timed it up by hand and took it for a run and it seemed to pull better, but I still had some sputtering when it warmed up (a problem I already had..), I will time correctly as I bought a timing lamp today.
Some points with the one I got, the parts that stated they were black in the instructions were actually red, the leads to the coil were too short and I cut the plastic bung in teh dizzy side wall to hold the rubber gromet in place.
One other point is that the wires in the cap could move and rub on the spindle or catch the rota arm does anyone have a solution?
Other than that its fine.