Hi,
I tyred a SU (hs4) which i still have but you need to make a manifold to fit it to, i used a right angle gas pipe the right size and welded flanges onto it.
This carb did work very well and had an k&n filter fitted to it, this run a 650 engine with a Gas flowed head and extractor manifold with inch and half exhaust.
Plus side it gave 35bhp on the rolling road with this set up but was dificult to start when warm as the pulse of two cyclinders caused the pump action in the carb to run rich on turn over but it did always start so [-/. mph was good to and drivability.
Ps you can mod the original carb as this is a good flowing carb for a standard engine (just because it standard equipment dont think its bad the only problem with the original carb it does not over fuel when you suddenly open the throttle.
Steve