Hi, the timing marks are, from top to bottom:
20 degrees BTDC
15 degrees BTDC
10 degrees BTDC
5 degrees BTDC
TDC
Setting Idle:
(This is a Fiat 500 carb, but its very similar)
(A) Idle speed screw: a sprung screw on the throttle arm of the carburetor, turning it speeds up or slows down idle
(B) Idle mixture screw: just to the right of the throttle arm, set into the base of the carburetor, turning it alters the fuel/air mix. They sometimes have a little cover though this is usually lost.
1. Make sure valves, points and timing are good.
2. Run the engine until it is nice and hot
3. Turn the idle speed screw until the engine is running at a speed you are happy with (about 900 rpm, but its normally by ear).
4. Adjust the idle mixture screw until the engine is running at its smoothest - close it and then slowly open it until its sweet.
5. Re-adjust the speed screw if necessary.