hi nigel,thanks for the input,yes,im running a panda 30 twin port head,slack day at work today,so all is brazed/painted and ready to go again,fitting all tomorrow.
the reason i didnt go down the 'bobbin' route was because the carb was vibrating too much already,causing reversal,i needed a firmer fixing,the system i had worked great till it broke.......................
anyhow,all done now and back on the road tomorrow...........i also found the bell crank for the (standard) throttle linkage was vibrating,so ive drilled and tapped that,and fitted a cute little grub screw with a ball in the end to preload the linkage
as for dif carbs etc,no rolling road here,so im just giong on accepted 126 euro folklore on whats what to fit. it looks goes and sounds well with the bits i have fitted,bogs a bit from idle but thats ok....sounds great when on full throttle,cannot wait to wind it up a bit more,i will be keeping a red line of 5000ish for my un balenced motor