Author Topic: Wheel question  (Read 1871 times)

0 Members and 1 Guest are viewing this topic.

fiat126fzr

  • Member
  • *
  • Posts: 38
  • Karma: 0
Wheel question
« on: July 30, 2013, 07:53:12 PM »
I have searched and searched wheels and offsets and what is possible but haven't found anyone say they have fitted the following which I am looking at buying. I have read of people with greater offsets and sizes with no arch mods so feel quite confident. Car is a BIS and will be on 17cm springs and a reversed eye leaf with updated shocks inc rears up front.

Looking at 13x5.5j 4x98 et25 with 165x55x13 tyres. I know I should really be looking at an offset of around 35 but if I do have any issues with them fouling arches (I'm not gonna do any arch mods) I can always increase the neg camber.

What does everyone think?

Cheers

kev126

  • Super Member
  • ***
  • Posts: 473
  • Karma: 6
  • Built not bought
Re: Wheel question
« Reply #1 on: July 30, 2013, 08:56:16 PM »
We could get a rough idea of your car was to be standard height, but as you're lowering it you'll probably have to just go down the old trial and error route
1989 Fiat 126 BIS

fiat126fzr

  • Member
  • *
  • Posts: 38
  • Karma: 0
Re: Wheel question
« Reply #2 on: July 30, 2013, 09:13:41 PM »
Excellent... It wouldn't be fun if it was easy would it!

kev126

  • Super Member
  • ***
  • Posts: 473
  • Karma: 6
  • Built not bought
Re: Wheel question
« Reply #3 on: July 30, 2013, 09:26:01 PM »
Haha, just remember anything is possible. A used a sledgehammer to fit wheels on my old renault ;)
1989 Fiat 126 BIS

fiat126fzr

  • Member
  • *
  • Posts: 38
  • Karma: 0
Re: Wheel question
« Reply #4 on: July 30, 2013, 10:59:27 PM »
Decent engineering that, 'if in doubt give it a clout!'

I like to think with my arsenal of a grinder, a mig and a selection of hammers I can usually get the outcome I was [kind of] hoping for...

guy2yourleft

  • Member
  • *
  • Posts: 70
  • Karma: 0
Re: Wheel question
« Reply #5 on: August 12, 2013, 04:51:01 PM »
'if in doubt give it a clout!'

That is one of the best lines I've ever heard and I beg of you to let me use it in the future. I believe all life's problems can be solved with a hammer and a flathead screwdriver.

Good luck with your project!
I didn't do it!  ...unless it was good...  ...even then it's still debatable...

Proud parent of a '67 Ford Mustang, '83 Fiat 126, and '94 Ford Explorer: "Daddy's Lil Girls"

Ruggero58

  • Member
  • *
  • Posts: 18
  • Karma: 0
Re: Wheel question
« Reply #6 on: September 26, 2013, 09:42:14 PM »
Quote
'if in doubt give it a clout!'

The proper terminology is referred to as "Impact therapy"...   I've used it quite often...  Especially on computer equipment and other sealed electronic devices.   :P