Author Topic: New Member Seeking Advice  (Read 9088 times)

0 Members and 1 Guest are viewing this topic.

Piggy

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
New Member Seeking Advice
« Reply #15 on: April 03, 2006, 02:03:22 PM »
So you're recommending an Anchor and Chain for the really steep downhills?
Loads of cars lost their brakes completely on the Alps day! Scary!! :shock:

We picked it up yesterday and I got towed 50+ miles home on a solid bar behind a pickup truck. Not pleasant at all. I couldn't see where we were going to steer! :oops:

Still the car, on first glance, doesn't appear to be too rusty though some patching will be needed. The brakes weren't jammed on and the engine will turn over even if it won't start at the moment. :D

I got in it and tried to push the seat backwards only to find out it was already pushed back! So went to tilt it back a bit, to find out the back of the seat is fixed. :lol:
I'm begining to worry about deep vein thrombosis on the long trip! :shock:

Bruce

  • Super Member
  • ***
  • Posts: 338
  • Karma: 0
New Member Seeking Advice
« Reply #16 on: April 03, 2006, 03:20:11 PM »
i found the same problem in my 126s, i got around it bending the stop on the runner so the seat can go back further, leaves no knee room for the pasenger behind the driver so they have to sit with knees either side of the seat, but at least i can drive the car fairly easily the only problem being lack of elbow room. with the above "mod" it has alot more room for the driver to get behind the wheel that the Matiz, i found it virtually impossible to drive one of them because of the lack of room, it is even worse than the 126 before the runner is modded :)

Piggy

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
New Member Seeking Advice
« Reply #17 on: April 03, 2006, 05:29:04 PM »
I'll check that out, though there is talk of my mates brother inlaw coming with us, so 3 big lads in the back will really stretch the legroom issue :lol:

The car is at my mate garage this week being checked over to make sure it's worth spending some money on it getting an MOT, otherwise I'll be advertising it in the for sale section!! :oops:

paul harbinson.

  • Super Member
  • ***
  • Posts: 545
  • Karma: 0
New Member Seeking Advice
« Reply #18 on: April 06, 2006, 08:19:38 AM »
Don't sell it.Do the run.Look four wheel cylinder's cost about £30 if it need's them.Brake's are about £8 a set.Clean the brake pipe's grease the stub axle's check light's and level's,mot and bon voyage :wink:
Dante Giacoso, pure genius!

Piggy

  • Newbie
  • *
  • Posts: 9
  • Karma: 0
New Member Seeking Advice
« Reply #19 on: April 07, 2006, 08:53:55 AM »
The garage are not impressed! :cry:

They think it's a waste of time and money, but then again they are a buisness.
He's said that the brakepipes need doing, which isn't to bad along with a bit of welding. The other thing he's bothered about is the fact it doesn't run. :oops:
So hopefully over the next couple of weeks I'm gonna spend some time trying to get it going and then get it in for a MOT.
He's not a big fan of the car, put it that way! :)
Other threads have given me some good infor regarding checking the fuel pump etc so hopefully it'll be something minor. :D

paul harbinson.

  • Super Member
  • ***
  • Posts: 545
  • Karma: 0
New Member Seeking Advice
« Reply #20 on: April 07, 2006, 02:27:04 PM »
You can't get simpler than a 126......well maybe a wheel barrow :lol:
Dante Giacoso, pure genius!