Author Topic: WONT START - any ideas?  (Read 2474 times)

0 Members and 1 Guest are viewing this topic.

fly

  • Member
  • *
  • Posts: 82
  • Karma: 1
WONT START - any ideas?
« on: May 19, 2010, 11:04:05 PM »
I've finally got my engine back in after changing the head gasket and doing a thorough overhaul - i'm after some ideas, as I cant now get the engine to fire.

I'm getting a spark at the plugs (ive tried swapping the HT's round etc), ive set the timing to 10deg before TDC. I'm earthed, all cables etc are attached and the engine is spinning freely on the starter.  All I'm getting is intermittent backfire out the carb and exhaust - at least a foot of flames, nothing else at all, its not even trying to fire.

Any suggestions greatly appreciated because i'm all out of things to poke at.

Cheers,

Ian

smallcox

  • Super Member
  • ***
  • Posts: 433
  • Karma: 4
Re: WONT START - any ideas?
« Reply #1 on: May 20, 2010, 12:39:35 PM »
hi Ian,

This is a difficult one not being there, you say the engine spins freely on turn over, (too freely) have you set the tappet gap correctly you should have compression, also is the fuel pump pumping fuel to the carb? I am quessing you have not removed the cam so cam timing is good. Clean the points and fit another condensor..  ???

does this help? keep me posted

Steve
air cooled, gt15 garret turbo with intercooler, 14x9" wheels with 225/40/14 toyos, front arb and disc brakes

thepuddlejumper

  • Super Member
  • ***
  • Posts: 685
  • Karma: 2
  • Location: Scotland
Re: WONT START - any ideas?
« Reply #2 on: May 20, 2010, 12:58:13 PM »
Hi Ian, did you remove the distributor? check to see the rotar is at the correct possition when No 1 is at TDC, could be a tooth out.

Ralph
« Last Edit: May 20, 2010, 01:01:33 PM by thepuddlejumper »

rockchevy85

  • Member
  • *
  • Posts: 26
  • Karma: 0
    • http://myweb.tiscali.co.uk/camaro/bambi
Re: WONT START - any ideas?
« Reply #3 on: May 26, 2010, 01:02:18 PM »
Flames from the carb would suggest the engine is firing while the intake valves are still open, so my first port of call would be the valve gaps as mentioned by smallcox (could be too tight which would mean no compression and some dramatic backfire through the carb).

stefanikoss

  • Member
  • *
  • Posts: 29
  • Karma: 0
Re: WONT START - any ideas?
« Reply #4 on: May 26, 2010, 04:33:04 PM »
hi there try take off the valve cover and start my fiat was doing the same when i tok off te valva cover my started i had tightend te bolts to tight and the valve cover hit the rocker arms

i might be wrong but try

fly

  • Member
  • *
  • Posts: 82
  • Karma: 1
Re: WONT START - any ideas?
« Reply #5 on: June 29, 2010, 10:07:20 PM »
I finally got my engine starting on the button a few weeks ago, was getting ready for a short test run and the starter went; I've had the starter on for around a week and he won't start again, no matter what I try, just back to occassional back fire through every orifice.  I'm fast loosing the will to carry on, anybody know what can cause the engine to run one week and flattly refuse the next, or even better live near Sheffield and have a garage I can offload it on. Spirits low, annoyance high.

smallcox

  • Super Member
  • ***
  • Posts: 433
  • Karma: 4
Re: WONT START - any ideas?
« Reply #6 on: July 07, 2010, 04:48:02 PM »
, no matter what I try, just back to occassional back fire through every orifice.  I'm fast loosing the will to carry on, anybody know what can cause the engine to run one week and flattly refuse the next,

Hi Fly,
   I sent a PM. but just reading your quote above don't give up, is the fuel pump working as if the engine sits for a while the fuel could be draining back to the tank and if the pump is suspect is unable to pull it back up to the carb because of an air lock in the pipe. :(

Thanks Steve [-/
air cooled, gt15 garret turbo with intercooler, 14x9" wheels with 225/40/14 toyos, front arb and disc brakes