Author Topic: Starting  (Read 1740 times)

0 Members and 1 Guest are viewing this topic.

Amateb8

  • Subscribers
  • Super Member
  • ****
  • Posts: 2148
  • Karma: 8
  • Location: London
Starting
« on: February 20, 2010, 12:47:48 AM »
My car starts 99.9% of the time after a short spell of non-usage. I noticed that now, occassionally from cold, when I turn the ignition, it would just "click" (no cranking). On the second or third attempt, it would crank normally. On the fourth attempt, it would start almost immediately. Took it for a drive for about 30 minutes, noticed the low fuel warning, so drove to my local petrol station, filled it up with petrol, paid for the petrol, got back to the car to go. Turned the ignition, it just "clicked"! On the second try, it started straightaway. What could be the problem? The starter? A friend of mine mentioned it could be the solonoid? Does the 126 Bis have a solonoid? The battery appears to be fine particularly after I installed a battery isolator.

Pete126

  • Administrator
  • Super Member
  • *****
  • Posts: 3369
  • Karma: 35
  • Location: West Yorkshire
Re: Starting
« Reply #1 on: February 20, 2010, 01:48:17 AM »
It probably is the solenoid Ive had the same problem, they are easy to fit and are alot cheaper than buying a complete starter motor. But before you do that check the the connection at the back of the solenoid and make sure it is good and tight (the thin wire with the spade connector)
Pete.      il cavallo piccolo

Amateb8

  • Subscribers
  • Super Member
  • ****
  • Posts: 2148
  • Karma: 8
  • Location: London
Re: Starting
« Reply #2 on: February 20, 2010, 08:06:10 AM »
Pete126, Many thanks. Presumably, the solenoid is the other cylindrical gizmo attached to the side of the starter. This can only be accessed from underneath the car?

Pete126

  • Administrator
  • Super Member
  • *****
  • Posts: 3369
  • Karma: 35
  • Location: West Yorkshire
Re: Starting
« Reply #3 on: February 20, 2010, 08:37:01 AM »
You can check the connections from the engine bay by taking the air filter box off the back panel, but to replace the solenoid the starter motor has to be taken off :)
Pete.      il cavallo piccolo

ciaoflyer

  • Super Member
  • ***
  • Posts: 1325
  • Karma: 3
Re: Starting
« Reply #4 on: February 20, 2010, 10:33:09 AM »
It probably is the solenoid Ive had the same problem, they are easy to fit and are alot cheaper than buying a complete starter motor. But before you do that check the the connection at the back of the solenoid and make sure it is good and tight (the thin wire with the spade connector)

Where can you get a solenoid from?
Ciao4Now

Rusty's Uncle

  • Subscriber VIP+
  • Super Member
  • *****
  • Posts: 2837
  • Karma: 34
Re: Starting
« Reply #5 on: February 20, 2010, 11:46:46 AM »
 :) 126FAN.sk are doing them for 23 euros . In the ELECTRICITY section and described as Electro Magnetic Starter Coil which of course it is  [-/