Author Topic: Teething troubles with newly resurrected BIS  (Read 1424 times)

0 Members and 1 Guest are viewing this topic.

ScimitarMatt

  • Member
  • *
  • Posts: 26
  • Karma: 0
    • http://www.reliantcars.co.uk
Teething troubles with newly resurrected BIS
« on: May 10, 2008, 01:06:39 AM »
Well,

now my 1993 Bis is on the road, it's undergone plenty of runs out to shake it down and break all those little things that are just ready to conk out.

so far the fuel pump has failed but i had a spare off eBay, then the thing would not run over 35mph. Turned out after much head scratching to be a clogged fuel filter, £1.50 later for a new one and I've just gone on a 70mile round trip, touching 81mph according to the sat nav, and it has not missed a beat. MINT :D


The only concerning thing is the temp gauge which reads one mark under the red zone if I'm on the motorway, foot to the floor. It has never overheated or entered the red zone but what is normal on a BIS?

Also, how easy is the headlining to replace as mine is so rotten when you drive with the windows open, the incoming wind rips the fabric and rains brown dust on the occupants, not cool!!  

cheers all from a happy 126er, Matt

p.s. a radio is the next job along with a cigar lighter for powering the satnav. The iPod is OK but I'm sure it's not legal to be driving while wearing it with sound canceling headphones
.............................<br />www.reliantcars.co.uk<br />www.scimitargt.co.uk<br />www.scimitargte.co.uk

ciaoflyer

  • Super Member
  • ***
  • Posts: 1325
  • Karma: 3
Teething troubles with newly resurrected BIS
« Reply #1 on: May 10, 2008, 09:59:41 AM »
Hi

Loads of posts on here about cooling system, whatever you do don't let it enter the red!  First of all drain the system and clean out thermostat housing so it sparkles.  Refill system with a good antifreeze 50/50 with water.  You can buy a kit that relocates the themostat to the cylinder head, where it should be, and this helps.  You could fit a manual override switch for the rad fan, I have done this and it works very well, you can cool when you want to!

Headlining, I just pulled mine out and didn't replace same colour under it as rest of car but it's up to you!

Hope this helps!
Ciao4Now

Gordan

  • Subscribers
  • Super Member
  • ****
  • Posts: 1689
  • Karma: 8
Teething troubles with newly resurrected BIS
« Reply #2 on: May 10, 2008, 02:28:33 PM »
First of all its really nice to hear another Bis is back on the road.  :D

Not much advice i can offer, but here its is: The heating prob could be caused by the inicator on top of the engine? as for the thermostat, i suggest you rip it out. I dont know about other members, but my Bis has lost her at a young age (the thermostat :)) and so far no heating probs have occured, and the headgasket is stil original...  :wink:

as for the headlining, i ripped mine out, and glued a nice piece of red carpet,  and it looks really nice...

hope any of this helps.

Another happy 126er  :D
PLEASE FOLLOW MY PROGRESS ON IG: https://www.instagram.com/fiatbis/