Author Topic: Bis Plastic  (Read 1985 times)

0 Members and 1 Guest are viewing this topic.

punkydog

  • Member
  • *
  • Posts: 66
  • Karma: 0
Bis Plastic
« on: April 06, 2007, 12:38:50 PM »
Due to Custom Coatings making a mess of my black platic bits I need some more.

126 BIS -pair rear airvents, front fresh air intake and blanking plate, all must be un-cracked and complete.

wiper bezels and nuts - does anyone know if BL mini ones fit, or any chrome type?

[email protected]
Brian

bis13

  • Super Member
  • ***
  • Posts: 2749
  • Karma: 39
Bis Plastic
« Reply #1 on: April 08, 2007, 07:48:32 PM »
i shall look in my bis parts bin i know i do have vents , blanking plate will find open intake . did you try to paint them (chrome)?

punkydog

  • Member
  • *
  • Posts: 66
  • Karma: 0
Bis Plastic
« Reply #2 on: April 08, 2007, 10:39:17 PM »
Yes- spray chrome, very disappointing, very expensive, very slow, and actually a very poor paint job aside from the fact it was just lacquered silver paint - I really could have done better with a rattle can. Sending next lot to US where they have been doing it for ages. Actually I think I just need the rear air intakes grilles. There were two sets on eBay last week but they block you from making contact. Even with the poor chrome effect the air intakes look good.
Let me know of you have some.
Brian