Darrell,
When you mention end play i quess you mean crankshaft end float,
have you measure this end float with a DTI anything under 15thou dont worry to much, however i beleive you replaced these bearing because off oil pressure problems?
If new bearings are used you would expect less than this, check all the parts behind the pulley are sitting correctly including the oil thrower because only the front bearing controls crank thrust, (never set the endfoat to small as the crankshaft can pinch when you get crankshaft flexing at high revs).
I have not got the standard clearances for crank end float with me at presant
SORRY
Steve