Hello to everybody.
That's the right one for 126 engines:

The thoot for the setting of the advance at the idle is the first on the left, so jokke was right.
On later polish 126s were used 2 diffrent idle settings accordind the diffrent ignition ecus.
From 1994 to april 13 1995(engine 37077822) were used cinquecento ignition ecus(nanoplex med 210/211A) with idle at 4° BDC,then 10° BDC with nanople med 213A.
Here you can the ignition maps of 210/211(a) and 213(b).

The 3 diffrent ecus:

Look at the pulley and the sensor with its bracket on the engine:

See how to set up the ignition:

When the center of the sensor and the center of the thoot meet each other the ecu recognizes it as the advance at the idle,if it happens 10° BDC that will be the idle,x° before TDC x° at the idle.
What is important fpr the ecu is the sequence of the theet so it doesn't matter how you build your home made trigger wheel and where you put the sensor.
Some exemples:

In that case was used an adjustable flange on the pulley and fix sensor on the right.
Here a fix flange and an adjustable sensor bracket on the left:

Somebody uses to solder the 3 theet on the standard pulley too:


Do you wish an exemple of conversion on 126 bis too?





