I had the system from MBG in my 126 and it was great - started up with one pull at sub-zero, ran smoother and so on. It died because a piece of metal found its way into the dizzy and stuck to the magnet, ripping a hole in it as it spun - can't see that happening too often, whereas points close, the condensers fry, the caps track, etc, usually on a motorway or a six lane roundabout (I've probably said this before, but I had a police escort as I pushed my 500 off a motorway roundabout near Bristol due to points closing - funny now but it was one of those near death experiences I don't want again).
I am now back on points, but I'm using a new dizzy and keep a spare in the car - its easier to swap a dizzy than mess about trying to work out points/condenser, and either way the timing needs setting. I'll do the same when I go back to electronic - keep my other dizzy in the boot as a spare, so if you have an FSM engine, then just by an Italian dizzy and keep the Polish one as a back up - I got a NOS distributor on ebay for £10. MBG also told me they were on the case with the Polish ones - creating a universal kit, which may be why they are selling off their current stock?
I also use the great Polish twin spark coil which is bullet proof and gets rid of the cap and rotor.
BTW, MBGs system is also a halfway house as you keep the coil. Also worth noting that on an FSM with twin spark, you either need to move the ballast resistor to the engine compartment, or run wires to the boot, as the system needs to take the (+) before the resistor.