1. Remove the can with the air filter. Disassemble all of it so you can have in your hand only the top part - the one that is closing all of it from the top and is delivering the air to the engine.
http://126p.no-ip.info/fotki/bis_dolot/100_2088.JPG2. Take the angle grinder or other tool like that and cut off all of the bottom part of this pipe. This should look somewhat like this:
http://126p.no-ip.info/fotki/bis_dolot/100_2089.JPG . Now the air will be taken not only from the one narrow side, but from all the width of the filter.
3. You can also direct the rubber pipe that is developing the air to the filter can catercorner downward toward the gearbox. Additionally if you have in this can a switch winter/summer you can take out from the silencer and the filter can leaving the hole open and set the closing plate vertically or lightly slanting right. If there will be small amount of air the engine will suck fresh air that it needs and if there will be too much air it will be gone by this hole.
All of this improved the performance of my engine - not anything amazing, but it helped.
Remember about changing the air filter regularly.
Designations of air filters made by different manufacturers:
- Sędziszów WA 50-120,
- Filtron AP 019,
- Champion u580/606,
- Kager 12-0124,
- Mmann-filter c2629,
- Magneti Marelli 150010037200.
If you like hardcore you can totally remove the air filter can, leaving only the hole to the silenter of additional sounds (?) on the pot. I was driving like that a few times and it really improve the performance of the engine, but you should use it only on short distance on asphalt because you cant allow the sand to get to the pot.
Fifi from
http://126p.no-ip.info/Hope it will help you
