Author Topic: spot welder  (Read 1733 times)

0 Members and 1 Guest are viewing this topic.

Darrell

  • Super Member
  • ***
  • Posts: 1715
  • Karma: 4
    • facebook profile
spot welder
« on: July 26, 2010, 12:48:48 PM »
'84 aircooled 126 & 500F still in kit form
Not the only African in the village :)

Rusty's Uncle

  • Subscriber VIP+
  • Super Member
  • *****
  • Posts: 2837
  • Karma: 34
Re: spot welder
« Reply #1 on: July 26, 2010, 02:06:27 PM »
That is a mickey mouse variation on the carbon arc torch which relies upon the two faces being welded being in close proximity so that the arc can melt a hole through the near side to the outer panel and if you are lucky the metal may fuse around the hole. Unfortunately you would not know if it has been a success until the joint fails or you do a destructive test. You want a proper spot welder (resistance welding) like the one I have. The copper electrodes clamp the joint together then blast the amps through . The point of high resistence is the joint face so the steel melts then fuses in an instant. It is the way most vehicles are assembled  [-/

bis13

  • Super Member
  • ***
  • Posts: 2749
  • Karma: 39
Re: spot welder
« Reply #2 on: July 26, 2010, 08:12:52 PM »
i suppose for the amount of money it goes for its worth a look at but like rusty said i wouldnt trust it to use on a car where the integrity of the weld could jepodise body strength.

Pete126

  • Administrator
  • Super Member
  • *****
  • Posts: 3369
  • Karma: 35
  • Location: West Yorkshire
Re: spot welder
« Reply #3 on: July 26, 2010, 09:23:42 PM »
Not done allot of welding but i have put front wings on a vauxhall by drilling 1/8 holes every 15-20mm then welding the holes up with a mig welder if that makes sense.
Pete.      il cavallo piccolo

landyman

  • Super Member
  • ***
  • Posts: 127
  • Karma: 2
Re: spot welder
« Reply #4 on: July 26, 2010, 11:23:01 PM »
used something very similar in the 1980,s practice on similar metal thicknesses until you are happy with the result and don't rely on the weld for anything too structural just for cosmetic panels/sheeting but price ok for what it does
     good luck andy

Darrell

  • Super Member
  • ***
  • Posts: 1715
  • Karma: 4
    • facebook profile
Re: spot welder
« Reply #5 on: July 27, 2010, 11:20:24 AM »
Going to hire a proper job... [-/
'84 aircooled 126 & 500F still in kit form
Not the only African in the village :)