i have just done mine james, took me a wee while, but i drove her yesterday, sounded sweet! i think its possible to do the head gasket in situ, but its easier to work on with the engine where you can get at it. if youve never done anything like this before, like i hadnt, its a bit more complicated than i first imagined, and I had some good advice from a mechanic friend which was invaluable.
theres a step by step guide to dropiing out the engine in the bis workshop manual ( i think you can download one, the link is on this site) , just drop it out onto a trolley jack , i took the gearbox out too, but you can leave that in, the workshop manual takes the gearbox out to, so easier to follow if you do that. theres a few fiddly bits when removing the engine but its quite straightforward, just tircky the first time if your not too sure where everything is, the pics in the manual arent very clear sometimes and words are minimal.
mark where all the cables, and hoses go, and unscrew all the right bits. make sure you keep all the nuts and bolts, washers etc, mark them carfully so you know where to put them when putting it all back together. Then you can drop the engine out. you need to remove the back panel of the car to do this, but its just all bolted on., so comes off pretty simply. make sure the jack is securely underneath the block before you ondo the engine mounting bolt. once its out youll need to reomve the exhaust manifold, rocker cover, and carb, remove the rocker arm (its all at the right hand side, as you look from the rear) ato get at all the cylinder head bolts. undo them all and slide off the cylinder head, , and remove the offending blown gasket.give it a light smooth scrape with a scraper, not sandpaper, to get rid of any stuck gasket, from both sides, but carfeul not to scratch or gouge at it. i took the head to get skimmed at an engine services specialist, definately best to get this done, cost about 40 quid
when your ready to put it all back together, get a hold of a torque wrench, and feeler guages, and put the new gasket into place. follw the correct tightening order of the head bolts, and only tighten them to the specified torque in the manual, or i think theres another one elsewhere on this sight with different tightening instructions, - search for bis cylinder head torques in the forum.
put all the rest back on, youll need new gasket for the carb, and exhaust ,and rocker cover and when youve put the rocket arm back on, set the valve clearances using the feeler guages.
then reverse the engine removal process, connect it all back up, fire her up with the spark plugs out, to make sure it runs ok if it all sounds good, put the spark plugs in and your good to go.
hpe this is of some use, i found it quite tricky to find a good walkthrough, but it was quite a logical process, one step at a time. give us a shout if any of this is a bit unclear