Head bolts

[126redbomb]

Hello I am having a nightmare with this car at the moment. I think I am missing bolts from the bottom head (I haven't got a clue what I have done with them ) if so does anyone know what size they are.

[126redbomb]

Hello folks I am still trying to find the bolts for the head but not sure if these are the right ones

[Pete126]

The studs you posted are for the head (yellow in picture) your looking for the 2 long X 1 short (red) if anyone has any spares for the Bis engine
 

[126redbomb]

That's correct Pete, I have asked around and I'm at a dead-end.

[ChrisRLewis]

Is this for a Bis engine or an aircooled engine?

[Pete126]

Bis 704cc water cooled

[126redbomb]

I'm in stalemate till I get some bolt 

[Pete126]

I'm sure you or some friends have some old metric bolts hanging about find one that screws into the block easy by hand then take it to a hardware store to get the correct pitch of threaded bar + nuts (B&Q) cut the bar oversize but remember to add a thin washer and nut to the length , cut off the excess leaving 2 threads proud of the nut.

[126redbomb]

So the bolts are not stretch bolts

[Pete126]

NO the three nuts/bolts (Red Arrows) just nip the gasket up to stop oil leaks, hand tight or torque to 4 DNm