« previous next »
Pages: [1]

Author Topic: Oil filter  (Read 1964 times)

0 Members and 1 Guest are viewing this topic.

Da Londo

  • Super Member
  • ***
  • Posts: 287
  • Karma: 0
  • It's not the carb size that matters, it's the jet
    • Fiat 126 blog
  • Location: Maasmechelen, Belgium
Oil filter
« on: July 12, 2016, 05:25:16 PM »
I inspected my oil filter today and found the shim bent, is this factory standard?


Logged

Rusty's Uncle

  • Subscriber VIP+
  • Super Member
  • *****
  • Posts: 2837
  • Karma: 34
Re: Oil filter
« Reply #1 on: July 12, 2016, 07:20:54 PM »
That looks nice and clean in there. I think that the part you are calling a shim is actually the crankshaft retaining hollow bolt tab washer which you bend onto the nut after you have torqued it up and stops your crankshaft from going walkabout if the bolt worked loose  :)
Logged

ronb1967

  • Subscribers
  • Member
  • ****
  • Posts: 63
  • Karma: 2
Re: Oil filter
« Reply #2 on: July 12, 2016, 10:01:00 PM »
yes i agree its a lock tab
Logged

Da Londo

  • Super Member
  • ***
  • Posts: 287
  • Karma: 0
  • It's not the carb size that matters, it's the jet
    • Fiat 126 blog
  • Location: Maasmechelen, Belgium
Re: Oil filter
« Reply #3 on: July 13, 2016, 10:57:25 AM »
Aha! So when I replace it I'll bend it again. Thanks!
Logged

Joe Webb

  • Super Member
  • ***
  • Posts: 147
  • Karma: 1
  • 1999 Fiat 126p elx, 1981 Matra Muren, 1971 Greeves
  • Location: Hove, UK
Re: Oil filter
« Reply #4 on: July 17, 2016, 01:06:17 PM »
I replaced the front oil seal recently and realised I'd forgotten to bend the new washer up after I'd reassembled and remounted the engine...

 :cry:

All better now though
Logged
1999 Fiat 126p elx, 1971 Greeves Pathfinder, 72 Datsun 240z
Pages: [1]
« previous next »