The coil on the BIS looks like a black round-ish thing normally bolted to the right forward part of the engine compartment. Out of if come the two HT lead (big thick wires) to the spark plugs.
The condenser is a small roundish silver piece screwed to the side of the distributor.
The distributor has a black cover with two screws on it and is found centre of the engine at the rear of the engine. The distributor has a single wire coming out of it and has a small hose coming from it.
Inside the distributor you will find the points which have to be adjusted to open to a specific amount (cant remember off the top of my head what that is now but less than 1mm)
First port of call in my opinion would be to check the points are indeed opening to that specified amount which can be measured with a feeler gauge probably halfrauds will have a set.
Specifications and instructions are available on this fine website in the haynes manuals which are available to subscribing members. The subscription is a donation of how much you decide

I strongly suggest doing this as the manual is so valueable and it's a mighty fine website with loads of help from many experienced people on it [-/
I hope I am not over simplifying my descriptions but thought it best to be as clear and simple as possible.
