Pete have you not fitted needle roller bearings on your bis and they work fine?
I did try the needle roller bearing at the rear of the engine, had the bearing cap machined out to fit and left a 1.5mm shoulder on the outside of the carrier so the bearing wouldn't work loose to the rear oil seal, the bearing had a centre hole in the outer casing which was pressed in with bearing seal and aligned with the oil channel in the block, It worked well for 200 an odd miles then oil started to pour out of the rear seal, when i took it apart the bearing outer case had worked loose in the bearing cap, and had worked through the shoulder then pushed the rear oil seal out, so not very successful

Don't know if it was something I did wrong :undecided2: but it nacked the crank so reverted back to the standard bearings and a spare crank I had [-/
Darrell, Who do you think planted the Seed, Sorry Steve :wink2: