10mm threaded bar can be used through a piece of timber and fitted into the hole in the engine casting that the bracket that all the pipes are held in on top of the engine.
Remove the hoses from the braket, remove the bracket and the stud from the engine, thread the threaded bar through the timber with a washer and nut on the top side of the timber, screw the bar into the engine and do up the nut until you start to raise the engine.
You will need to cut the timber so that it bears on the left and right side of the engine bay.
This is a good method if you think you may have the rear valance off the car for any length of time and it means you can use the jack for other jobs.
Tried and tested.