haha, it's very easy, but requires a little soldering (easy soldering). all you have to do, is geta disposable camera with a flash, take it apart, take the battery out and take a photo with flash turned on before you do anything or itll hurt you, inside the camera there will be either two or three wires attached to the flash bulb, if theres three, get rid of the middle one, you just want the two end ones. disconnect them from the bulb, these go to your shock wires. there will probably be two switches in the camera, one to turn the flash on, and one to take a photo, in my experience the best way is to just solder the terminals so that both the switch and the button are permanently on.
from here, if you want to test it, you can put the battery back in, then wait for the light to come on saying it's ready to "take a photo" then touch the two wires to a piece of kitchen foil, it should blow a couple of little holes in it.
dont keep playing with it by touching metallic objects, personal experience says it overloads the circuit and kills it. human hands wont do that, theres enough resistance. also it wont make burns on your hands like it does to foil, the resistance dulls it down enough to just hurt without causing lasting damage.
after this, it's up to you how you give it 1.5v so you dont have to use a battery. i could probably come up with a regulator circuit or something if you want to do more work, otherwise i recommend getting one of those cigarette lighter adaptors which has a bunch of voltages so you can use portable electronic equipment in the car, just modify it so it connects to the car battery via a fuse instead.
it all sounds hard in writing, but give it a go, it wont take long at all.
for best effect you probably want either one camera for each wheel arch, or one for each side of the car. the only reason is that once it shocks someone, it takes 10 or 15 seconds to charge up again, and i dont know if it will charge while someone has their hand over the wires.. meaning if two people went to grab a wheel arch each, one would get a shock, and the other wouldnt. another good way might be to have one camera for the front, and one for the back. people will usually just go from one side.
another note, definately put the whole thing in a plastic box of some kind, the board itself can shock you just as easily as the wires coming off it, and also if the wires coming off touch bare metal they can attach themselves via a weak spot weld:P
also i can vouch that you wouldnt want to put your hand back in there if you got bit by this, i always manage to shock myself making these.
on a legal note, im pretty sure these are just a grey area, i think you are allowed to modify a camera in this way, since it cant actually kill you. using it as a security system in a car might cause frowns from an mot guy though.. probably wanna make it removable.
there are guides online for making a camera stun gun, its the same thing.
i hope nobody gets upset with me for posting this, i almost feel like ill get in trouble.
all it is is a zap, scares the crap out of you, and probably stings for a while. nothing particularly dangerous, but its effective.