Well I could'nt resist it any longer so started Tinkering with my 126. My hands were dirty anyway from changing the rocker cover gasket on my Astra( dont EVER use the rubber gaskets, they are bloody impossible to stay in place as you doo up the nuts !!! use the cork one's)
I took both the bumpers off and what looked like just bubbling under the paint fast turned into a whole big enough for the neighbours cat to crawl into. the front O.S, rear O.S and rear N.S lower bottom corners have all got a fair bit of rott. One whole had what loked like compost falling out of it as I dug around with my fingers !!
But I think I should be able to rebuild the corners with bridging mesh and filler. I dont know what the best stuff to use is so any words of wisdom would be great.
I took the lining off the roof as a previous occupant, of the four legged veriaty, has ripped the hell out of it. I'm going to use the old one as a template and cut out some carpet as a replacement. That should do it !!!
I want to try and keep it origional but the seats are not very good. If you get "tail-ended" by someone then you'll get snaped in half as the seat back is so low and has no head rests.
I tryed to interduce my digital camera to my computer this afternoon but they are still not talking to each other. The computer did make the effort and now recognises the usb cable, but the camera was having none of it and decided its batteries were exhausted and swithed off. So I'v got them on charge and will try to match-make tomorrow. I'll get some pickies later.
The under side dose'nt look too bad and I have only found one wee soft spot. What do you call the stuff used as the "Underseal"?
I recon it could do with a new coat of it on.
Thanks for any advice you have as I'm new to 126's(and female) and want to do a good job on her resteration.
Issy. :roll: