Club126UK
Fiat 126 Chat => Fiat 126 Chat => Topic started by: BigNik on September 06, 2014, 11:56:45 AM
-
Guys,
Anyone here slammed there 126? I have a 91 air cooled and really want to lower it. Can anyone recommend where to source parts from etc?
Thanks,
Nik
-
I am just looking to have some coil overs made for the front and get rid of the leafs, then some shorter springs for the front, let me know how you get it done though :)
Sent from my iPhone using Tapatalk
-
Go to Google and type in fdrecaqmbi it will say fiat 500 spares, click on that, then subheading 126 and look under their listing for 'undercarriage'. They supply coil over front and rear suspension units. Also lower wish bone units attached to a cross beam.
-
Yes rick! Thankyou! Your are now my new favourite person and I will think of you like a god 👠you may of saved me a few hundred squid! âœŒï¸ thankyou
Sent from my iPhone using Tapatalk
-
Sorry I know this is bigniks post, however would need to but a new subframe to use the coil overs for sale on this page, like then the wishbones are on the end so would I need anything else like instead of the leafs?
Sent from my iPhone using Tapatalk
-
Cut coils on the back, reverse eye spring on the front with cut down mounting blocks are a simpler start , that will get you fairly low.
-
I was going to do that too stuey but I've got over a year until I'm driving it yet so I've got enough time to save and do it properly, might aswell :)
Sent from my iPhone using Tapatalk
-
Thanks Guys :D
-
ebay Italy for sports suspension! :-)
Sent from my iPhone using Tapatalk.
-
Cut coils on the back, reverse eye spring on the front with cut down mounting blocks are a simpler start , that will get you fairly low.
Ditto. This is how its been done on these car for years by thousands of people. To do it properly as you said it will cost you mega money. budget about £1000 + to get the coilover set up fitted.
http://webshop.fiat500126.com/katalog/showarticles/360500/1/chassis
http://webshop.fiat500126.com/katalog/artikelinfo/7858/front_axle_single-wheel_suspension_inclusive_struts
On a standard engine you really don't need to spend this type of money. Are you lowering it to handle better or just look cool? of its to handle better, have you driven it hard yet?