Club126UK
Fiat 126 Chat => Fiat 126 Chat => Topic started by: fiat126fzr on October 17, 2013, 05:59:50 PM
-
Has anyone got a water cooled rear suspension bump stop knocking about? That's the type that pushes/slots in to the chassis as opposed to screws in.
Cheers
-
Excatly what im after too! I can only see the screw type ones on ebay :(
-
I need one too! Was wondering if I could somehow get a nut to fit on the screw type one instead...
Haven't had a proper look at mine yet to see..
Or maybe just pump some grip fill up there instead :P
-
If you really want bump stops good luck, but if you only need them for the MOT then don't bother, it is only a fail to only have one bump stop, luckily both of mine fell off.
Marc
-
I bought a pair from my local Fiat dealer two years ago. It is the push in type, and it costs £54 (incl VAT) a pair. Part no is F0007688142.
-
Wowzer! 54 quid! ! Bugger that!..so I dont need them then?does the car bottom out much?
I just assumed if I didnt have them it would hit..
-
Mine hasn't bottomed out yet, and we often have all four of us on country roads, dirt tracks and hump back bridges. I've even got slightly airborne on a humpback bridge and not bottomed out on landing.
-
In that case im bining the other bumo stop! :D
-
Well if you bin your one and it comes out intact I'll buy it off you ;)
-
I just welded a nut into the hole and put a bolt in powerflex universal in there-
(http://i7.photobucket.com/albums/y271/cheekos10/SS851156.jpg)
-
In my case, it rarely bottoms out. That said, there are tell-tale signs that it has, and I do not carry rear passengers 100% of the time.
The Alfa Romeo GTV bump stops also fit, but are similarly priced.
-
If I can't source one I was just planning only welding a nut in and using air cooled ones
-
My other one fell off today lol so am just going for the economical welding/screw type fitment... Sod paying £54
-
The easiest way is to go to an exhaust fitting bay with your shocker and get some rubber doughnuts as pictured below, Extend the shocker and choose some that are a tight fit inside the cover :D Cut them so you can get them round the absorber center shaft, then push these up into the shock absorber cover this will stop the suspension from bottoming out:thumbup