Club126UK

Fiat 126 Chat => Fiat 126 Chat => Topic started by: fiat126fzr on July 30, 2013, 07:53:12 PM

Title: Wheel question
Post by: fiat126fzr on July 30, 2013, 07:53:12 PM
I have searched and searched wheels and offsets and what is possible but haven't found anyone say they have fitted the following which I am looking at buying. I have read of people with greater offsets and sizes with no arch mods so feel quite confident. Car is a BIS and will be on 17cm springs and a reversed eye leaf with updated shocks inc rears up front.

Looking at 13x5.5j 4x98 et25 with 165x55x13 tyres. I know I should really be looking at an offset of around 35 but if I do have any issues with them fouling arches (I'm not gonna do any arch mods) I can always increase the neg camber.

What does everyone think?

Cheers
Title: Re: Wheel question
Post by: kev126 on July 30, 2013, 08:56:16 PM
We could get a rough idea of your car was to be standard height, but as you're lowering it you'll probably have to just go down the old trial and error route
Title: Re: Wheel question
Post by: fiat126fzr on July 30, 2013, 09:13:41 PM
Excellent... It wouldn't be fun if it was easy would it!
Title: Re: Wheel question
Post by: kev126 on July 30, 2013, 09:26:01 PM
Haha, just remember anything is possible. A used a sledgehammer to fit wheels on my old renault ;)
Title: Re: Wheel question
Post by: fiat126fzr on July 30, 2013, 10:59:27 PM
Decent engineering that, 'if in doubt give it a clout!'

I like to think with my arsenal of a grinder, a mig and a selection of hammers I can usually get the outcome I was [kind of] hoping for...
Title: Re: Wheel question
Post by: guy2yourleft on August 12, 2013, 04:51:01 PM
'if in doubt give it a clout!'

That is one of the best lines I've ever heard and I beg of you to let me use it in the future. I believe all life's problems can be solved with a hammer and a flathead screwdriver.

Good luck with your project!
Title: Re: Wheel question
Post by: Ruggero58 on September 26, 2013, 09:42:14 PM
Quote
'if in doubt give it a clout!'

The proper terminology is referred to as "Impact therapy"...   I've used it quite often...  Especially on computer equipment and other sealed electronic devices.   :P