Club126UK
Fiat 126 Chat => Fiat 126 Chat => Topic started by: Hazey-n-Marc on March 12, 2012, 08:15:08 PM
-
:yikes
Oh well, cheers to Stuey for loan of the light (went in fine), and quite liking the look of the 155/70/13's on the back. Now wondering if i put the same on the front or lower it! Window washers (front) working, had to use my rear washer bladder as I put a tiny split in the front one whilst cleaning what appeared to be pea and ham soup out of it. It was checked over by my mot station the week I bought it, they said there was no rot, so hopefully living this close to the sea and driving in the snow (amazing, my Bmw wouldn't even drag itself of off the curb!) hasn't eaten too much away. I may be experimenting with the sad smileys tomorrow, hopefully not.
Marc
-
Best of luck mate , sounds like you are well bladdered there :$
Hope you have got those king pins well greased up :)
-
Cheers Rusty
The king pins are a worry, been meaning to do them, just never got round to getting a grease gun. :$
Marc
-
That is a bit of a "Come as you are" approach but I guess that you can say "No I don,t have a gun" to the MOT man and if you get a pass you will be in Nirvana :$
-
They are odd car friendly, the owner has an immaculate austin a90
-
Good luck on your MoT. I used to get an advisory on my kingpins as it had a very slight play. The MoT chap who was familair with 500/126s did acknowledge that there should be a slight play but placed it on advisory to cover himself and the garage. He advised me to get the kingpins greased before the MoT and the kngpins would pass with no advisories - and he was right!!
-
Not enough time now :$
-
Failed on a missing drive shaft bolt and a loose drive shaft bolt. That's it :o
Marc
-
But did break down about 100 yards from the mot station, just blocked fuel filter again. I always carry a spare so no worries. Must fit the new tank.