Club126UK
Fiat 126 Chat => Fiat 126 Chat => Topic started by: Pete 126bis on November 08, 2011, 09:29:51 PM
-
Hi i have finally got my bis up and running after sitting in the workshop for a long time :) but after getting it up to temp i now have found that the main bearings have gone or on there way out as it rattles / rumbles on tick over , any tips advice on replacing the bearing , so for me it was 1step forward and 2 steps back but i new that when i brought the car it had been standing and driven quite hard before it came to me but iam still smiling cheers Pete
-
Great news you've got it running! Sorry to hear there's now more to do - but that really seems the way with these things!!
Good luck with it!! :)
-
I assume then that the oil light comes on ? If the light goes out on start up and stays off your main bearings will be OK and the rattle comes from elsewhere.
-
Hi the oil light came on with the ignition and went off when running , i do know that the previous owner did run / drive it with NO oil in as the drain dung was sitting on the radiator cowl and had nothing in and sat for a few years before it came into my hands , open to ideas, views etc cheers Pete
-
So if you have new oil in there and the oil light stays off when the engine is up to temperature that is a good sign. The rattle could be tappet adjustment , worn timing chain or just a loose or busted bit. Worst case would be worn little ends but that would be rare. If the engine runs OK I would check out the usual suspects and adjustments , keep an eye on the oil and see where you go from there