Club126UK

Fiat 126 Chat => Tuning & Customising 126 Models => Topic started by: badboy on May 11, 2011, 06:29:02 AM

Title: new member here
Post by: badboy on May 11, 2011, 06:29:02 AM
the home page shows 3 cars 2 with bumpers removed
i love the look of the middle one with the small over-riders and front spoiler
where are the short bumpers and spoiler purchased from?
i will be putting up images of my new purchase later tonight nicknamed badboy for obvious reasons
also does a J reg 1991 run on unleaded fuel or will it need an additive?
Title: Re: new member here
Post by: smallcox on May 11, 2011, 04:04:44 PM
Hi Badboy,
I found many articals relating to the fiat 126 cannot run on unleaded with out the valve seats being replaced. However as I, and most off the 126 owners now find it almost imposble to find leaded petrol you have little choice. I only put an additive in if I go on long motorway runs 8)

Ps that spoiler on the middle car on the Homepage is from a 1500 spitfire

Smallcox
Title: Re: new member here
Post by: ChrisRLewis on May 11, 2011, 04:12:13 PM
If it's a Bis Model i.e watercooled there's no problem using unleaded fuel.  :)
Title: Re: new member here
Post by: DEYAN IYI on May 11, 2011, 04:39:19 PM
According to www.126fan.pl (http://www.126fan.pl/www/glowica.htm), since 1990 the valve seats are suitable to unleaded fuel  ;)

Głowice te są aluminiowe przystosowane do benzyny ołowiowej ET 94, natomiast od roku 1990 zostały utwardzone gniazda zaworowe, co sprawiło, że można stosować paliwo bezołowiowe 95 lub 98 oktan.
Title: Re: new member here
Post by: badboy on May 11, 2011, 09:58:45 PM

lovin he bumper-less look and the additional small bumper over-riders are they bought from somewhere or just stuff you have to fabricate yourself?
thought the front spoiler looked familiar - did you have to modify as i thought spitfire had cut outs where spoiler fitted around frame posts?
Title: Re: new member here
Post by: smallcox on May 12, 2011, 06:54:31 PM
Hi,

spoiler fits, but you need to fill the gap at the top, I used ali sheet. ;D
Title: Re: new member here
Post by: badboy on May 17, 2011, 09:10:19 PM
what size wheels have you gone up to without any modifying of arches etc?