Club126UK

Fiat 126 Chat => Tuning & Customising 126 Models => Topic started by: markymarc on April 01, 2011, 09:09:47 AM

Title: Quick 1
Post by: markymarc on April 01, 2011, 09:09:47 AM
How much does taking one coil from the rear springs of a BIS lower it by?

Would like to know before I do it and then find my tyres and wheels don't fit!!

(5x13" X19 wheels - 165/55/13 tyres)

Many thanks guys
marc
Title: Re: Quick 1
Post by: smallcox on April 01, 2011, 04:45:40 PM
Hi Mark,

I am thinking you mean ET19 wheel offset. I run 5J rims on my car some time ago and had no trouble but can understand depending on offset if the wheels are going to hit the arch?

If you remove the spring and shock and lower the car on the jack this will give you some indiacation if theres going to be any arch to tyre contact. I cut Half a coil on my car rear spring and it only just changed the ride height but remember this does depend on offset of the wheels. Also when the wheel moves up into the arch the top off the wheel tips inboard more :P

some one on here has an answer that your after
Title: Re: Quick 1
Post by: Gadge on April 02, 2011, 10:06:10 AM
i did this with mine, just out of curiousity, cos i had a new set i was gonna fit. i cut one complete coil out, i found i had to do one coil as if i done half, then it would'nt sit properly in the seat of the suspention arm. when i lowerd it back on the ground the results - i found - were quite good. it sat very nicely - about 20mm i'ld say -  not to low to scrub the 155 13s that i have on. i would have left it like that only when i jacked up the car again did i notice a potential mot flaw.... when the arm hangs down after its been jacked up, the springs were loose? not just a little either, but quite alot and i'm sure that would be an mot faliure? so i when back to the original idea of fitting the new ones?