Club126UK

Fiat 126 Chat => Fiat 126 Mechanical Problem Solving => Topic started by: ypsilon_lancar on October 25, 2010, 03:47:50 PM

Title: Why do small easy jobs turn into nightmares???
Post by: ypsilon_lancar on October 25, 2010, 03:47:50 PM
With it being such a lovely sunny day here in Yorkshire i thought i would do a few of those little jobs.

1) T-Cut and polish the matt paint work to a super high gloss  :D

2) Change the gear box oil, never done this on any car but seems easy enough  :D

Drove to motor factors for some oil and mollyslip and on the way home drove over a manhole cover which caused the back end to slide a bit, mmm strange  :-

Got home decided to t-cut 1st whist everything cools off in the engine bay, hour later looking very good and feeling rather proud  :D

Next job, check haynes manual, yep seems easy. Drain oil, so far so good. Ready to fill up and the hole to refill is TINY, mmmm what to do? Look on the otherside for a bigger hole (wishfull thinking!!!) and to my horror the shock absorber is hanging out of the swinging arm, its punched right through!  >:(

So can anyone tell me how to get the oil in the gear box, and how hard is the swinging arm going to be to replace?  .:)

To top the day off, my intergrale has also decided to break, in sympathy maybe??
Title: Re: Why do small easy jobs turn into nightmares???
Post by: 126bis1997 on October 25, 2010, 05:39:04 PM
I am sorry about the shock mate sure some one will reply on how to do the job and regards
filling the gearbox use a funnel attached to a bit of long pipe that fits in the hole of the upper plug of the driver side at the gear box and fill from engine bay
Cheers
Title: Re: Why do small easy jobs turn into nightmares???
Post by: GTMaster on October 25, 2010, 06:39:29 PM
Didn't the loose shock absorber make a clattering noise (mine did)?
It's not too difficult to replace but everything has to be removed off the arm and put onto the new arm. Rotted in brake lines can be nasty. Need to be careful when removing the arm bolts and arm as there are spacer washers in there to adjust the toe on the rear wheels, so you'll have to put back the same amount of washers into the same place (what i did to determine which spacers came from where, as when i pulled the arm out they just fell everywhere: i sprayed the spacers on one side of the bolt with WD-40, while the others were dry. That way i knew which side of the bolt to put the spacers back into.) Best to have a wheel alignment done afterwards as well. My shock absorber had come loose at the top, so i just welded the plate back and all is fine.
I used a small piece of garden hose to fill up the gearbox with a funnel (garden hose isn't oil resistent but it fits into the  oil filler hole). Best to put a small clean container under the gearbox though as some oil comes out when pulling the pipe out.
Title: Re: Why do small easy jobs turn into nightmares???
Post by: bis13 on October 26, 2010, 08:47:34 AM
i have a huge syringe that i fill up with oil and although it takes a while it gets there and i find it easier than going down the funnel pipe route as i always end up with oil everywhere!