Club126UK

Fiat 126 Chat => Fiat 126 Mechanical Problem Solving => Topic started by: michaelodonnell500 on November 21, 2009, 02:50:21 PM

Title: door hanging, any advice?
Post by: michaelodonnell500 on November 21, 2009, 02:50:21 PM
Hi all,
Just bolted on my replacement drivers door and its sagging towards the rear of the door. I'm sure a bit of trial and error will get bolted in fine, but I was wondering if anyone had done this before and knew a good way to set it right.
Thanks

Michael
Title: Re: door hanging, any advice?
Post by: bis13 on November 21, 2009, 10:28:14 PM
like you say trial and error is it a new door or from a donor car as it could be suffering from effects of age or that at somepoint too much leaning on the open door has bent the hinge , you could use shims behind the lower hinge to raise it if nothing else works.
Title: Re: door hanging, any advice?
Post by: michaelodonnell500 on November 22, 2009, 11:49:40 AM
Yeah, it's off a donor car, I'll try  re-fitting the old door today, if it sags too then I know I'm fitting it wrong!
Failing that I'll have to manipulate the hinges in some way.
Title: Re: door hanging, any advice?
Post by: jose on December 16, 2009, 09:05:57 PM
i had this problem, door was too low at the catch and was clunking badly just to get it up to level with the 1/4 panel. adjustment on the hinge was maxd out too.  as stated above it's probably a result of too much leaning on the door which can bend the hinges over time.  dont be afraid to get under the door and give it all you've got to wrench it upwards! it'l creak and sound bad but very unlikely you can do any damage, the creaking is just the hinges bending back to normal!
Title: Re: door hanging, any advice?
Post by: stuey on December 17, 2009, 01:04:26 PM
as much as some one is bound to say its a bad idea I have with success used a trolley jack under a door before to correct saggyness...
Title: Re: door hanging, any advice?
Post by: Eklipze3k on December 17, 2009, 01:17:10 PM
as much as some one is bound to say its a bad idea I have with success used a trolley jack under a door before to correct saggyness...

I was so tempted to make a saggy old man joke but I think I'll leave it ;)