Club126UK

Fiat 126 Chat => Fiat 126 Mechanical Problem Solving => Topic started by: ciaoflyer on November 14, 2009, 04:52:29 PM

Title: Fitting Gearbox mounts on BIS?
Post by: ciaoflyer on November 14, 2009, 04:52:29 PM
Hi

Is it easy to fit gearbox mounts on a BIS, the manual makes it look easy....

Anyone got any ideas?


Title: Re: Fitting Gearbox mounts on BIS?
Post by: ciaoflyer on November 15, 2009, 08:56:27 AM
Has anyone done this?

Ta :)
Title: Re: Fitting Gearbox mounts on BIS?
Post by: Pete126 on November 15, 2009, 10:10:00 AM
Not replaced mine yet, but support the rear of the gearbox with a jack, clean the threads on the bracket, draw round the bracket with a magic marker although you should be able to see where the bracket was mounted once removed, spray with wd40 leave a few minutes, then undo one bracket at a time and replace, align the bracket in the same position as when you took it off :)
Title: Re: Fitting Gearbox mounts on BIS?
Post by: ciaoflyer on November 15, 2009, 10:15:59 AM
Thanks Pete, got one off and it fell to bits!
Title: Re: Fitting Gearbox mounts on BIS?
Post by: ciaoflyer on November 15, 2009, 07:31:06 PM
Replaced both mounts now, easier than I thought :D.  I have test drove it and the towbar, engine and gearbox don't come into contact anymore so no more banging! Great!  Anyway here's a pic of the old mount.....

(http://i32.photobucket.com/albums/d18/ciaoflyer/OLDGBMOUNT.jpg)