Club126UK

Fiat 126 Chat => Fiat 126 Mechanical Problem Solving => Topic started by: jimbob4212 on August 04, 2009, 08:21:37 AM

Title: Will not start - HELP!!
Post by: jimbob4212 on August 04, 2009, 08:21:37 AM
Hey need abit of help please...

My aircooled has stoped working and here is the story of how far I have got...

The other day I started it up and it ran fine untill it missfired and stoped. I changed the dizzi cap, rotor arm, condensor and points however it still didnt start. The tank is full, and everything else seems ok. I tested the wires going to and from the coil and I got a full 12v on both. However when I took the coil lead off and tried to make a spark their was nothing, there was also nothing when i tried to make a spark when looking at the plugs. It is almost like the coil is not pumping out enough power. Does anyone think that it could be a faulty coil.

All help would be great, cheers,
Title: Re: Will not start - HELP!!
Post by: Pete126 on August 04, 2009, 06:10:08 PM
Have you tried running a new wire from the coil to the dizzy, just incase its split somewhere, is there a spark when you flick the points?  if you get stuck PM me your telephone number I'm in South Leeds :D
Title: Re: Will not start - HELP!!
Post by: Darrell on August 04, 2009, 08:49:47 PM
If you take the dizzy cap off, rest the wire from the coil somewhere near the crankcase so as to see if a spark will jump, and then simply open and close the points with a scredriver.

Coils can go although not common. I have a few spare but Leeds is a bit far.
 :oops:
Title: Re: Will not start - HELP!!
Post by: Dan_535 on August 06, 2009, 11:31:34 AM
from what you say about the start and sudden mis-fire its more likely to be electrical than fuel and air delivery i.e misfire was too much petrol and not enough/ sudden spark in the cylinder. when checking the electrical system, dont forget to check the voltage regulator too as they can give up pretty easily, especially being where its located out in the elements on the aircooled causing corrision inside the casing. good luck, hope you get it sorted soon.
Title: Re: Will not start - HELP!!
Post by: jimbob4212 on August 07, 2009, 04:31:29 PM
Cheers for all the help chaps!