Club126UK

Fiat 126 Chat => Fiat 126 Chat => Topic started by: 1973/126 on February 17, 2009, 11:02:37 PM

Title: Unleaded cylinder head
Post by: 1973/126 on February 17, 2009, 11:02:37 PM
 Just a question. Does anyone know, if any of the late air cooled engines were fitted with unleaded cylinder heads? When did they stop the production of the air cooled engines? ???
Title: Re: Unleaded cylinder head
Post by: MaLi on February 18, 2009, 06:52:23 AM
The unleaded cylinder heads were fitted to aircooled made after mid 1991 - I had an info on engine number when the switch was made but cannot find it at the moment.

I was using pre-1991 head on unleaded and never had any problems - but I didn't do a high millage.

I think the only changes that were made for the unleaded head was the material of valve seats.
Title: Re: Unleaded cylinder head
Post by: 1973/126 on February 18, 2009, 07:00:47 AM
 Thanks for the info MaLI [-/ If you find the info for the engine numbers, respectively the head just post it on here.
Title: Re: Unleaded cylinder head
Post by: Eklipze3k on February 18, 2009, 07:47:20 AM
Is there any easy way to tell if a conversion has been made? I've not drive my '83 aircooled much yet and never thought to ask the seller  :oops:
Title: Re: Unleaded cylinder head
Post by: bis13 on February 18, 2009, 11:02:53 AM
well some say that due to the head being made of alloy it should have hardenned valve seats already but thats all not true , you can run easily on unleaded the rules usedto be every fourth tank fill with leaded but as its not available just use a good lead replacement additive i run without chucking it in from time to time and over a couple of years have not noticed any problems.
Title: Re: Unleaded cylinder head
Post by: Eklipze3k on February 18, 2009, 11:05:44 AM
Thanks Mick  [-/ Are additives quite readlly available?
Title: Re: Unleaded cylinder head
Post by: Rusty's Uncle on February 18, 2009, 12:48:47 PM
I had a spare head fitted with new valve seats as a precaution and it was not that expensive with only 4 valves but to be honest I have never heard of anyone running into major problems with the original set up plus it is so easy to check the valve clearances on a 126 that it is no problem to monitor the tappets.  :D
Title: Re: Unleaded cylinder head
Post by: bis13 on February 18, 2009, 02:48:17 PM
additives are found in any halfords , or auto shops.