Club126UK

Fiat 126 Chat => Fiat 126 Chat => Topic started by: joda on February 10, 2008, 10:03:19 PM

Title: holey biz!!
Post by: joda on February 10, 2008, 10:03:19 PM
was changing the front bumper on my biz today for a better one (plan to remove them when i can figure out numberplate)

 then i noticed the rear bumber wasnt sitting great, so i was trying to get the rear to slide into the holder in the drivers side, seemed to sit at an odd angle so i went to give it a wee tweek! and a hole has appeared!!! its not to bad, 2" x 1" high, just a bit bigger than the mount.

 is this a common problem with these?

 im also planning on removing the plastics from the bottom of the doors as i fear these also hold water.

    lastly, the 126 i robbed the bumper from was a polish aircooled one, still on polish plates, had really nice seats, one peice headrests, sadly tho the forklift chewed them up!

 got a set of fitted mats tho with 126 on them, went to fit them and they are for a left hand drive, no hole for the accelerator pedal, how i didnt see that i dont know, out with the knife tomoro!!!
Title: holey biz!!
Post by: Paulh81 on February 10, 2008, 11:33:23 PM
for a start its Bis, not Biz...  :lol:
Title: holey biz!!
Post by: joda on February 11, 2008, 10:47:39 PM
Quote from: "Paulh81"
for a start its Bis, not Biz...  :lol:



 that solves all my problems, thanks for your assistance :D