Club126UK
For Sale & Wanted => Wanted: => Topic started by: michaelodonnell500 on September 02, 2020, 06:51:03 PM
-
Hi, does anyone have an accelerator cable bracket for a bis,?
It is the bracket near the carb where the cable outer clips on to.
Thanks,
Michael
-
I can take some measurements if you want to make one. Shouldnt be that difficult
-
That would be great, thank you!
Am I right in thinking it mounts onto the cylinder head where the exhaust is bolted on?
I think the cable in my car is sitting at the right height vertically, but I don't know how long the bracket should be, that would be a big help.
Thanks,
Michael
-
Michael what make carburettor do you have fitted to your Bis? There maybe variations in the design of the bracket for different carbs?
-
Thanks Guys, I found the bracket!
It was in the front luggage compartment!
I picked up the car at the weekend, a number of parts have been stripped off of it. I'm not familiar with the bis engine so I didn't recognise the bracket at first, but the technical download section helped me to identify it.
Incidentally its a weber 30 DGF. The top thread for the airbox mount is badly damaged, but I'm awaiting a couple of scrap/spares 30DGF bis carbs, so I should be able to make it right.
I will have to start a restoration page on the car. Lots of rust, but very low mileage.....
-
Great:) Yes, it bolts on on top of the exhaust outlet.
I just did a complete tear down and rebuild of my BIS engine, so I might be able to answer your questions. You could skip the airbox and just put a filter on top of the carb. Thats what I did