Club126UK

Fiat 126 Chat => Fiat 126 Mechanical Problem Solving => Topic started by: Guldbergdk on September 02, 2020, 11:07:18 AM

Title: Wheel nut torque
Post by: Guldbergdk on September 02, 2020, 11:07:18 AM

I tighten the wheelnut by hand (assuming thats around 7NM) and back it off 30degrees as per instruction. But this means that its more or less free to rotate. I staked it, but its hard to “fill” the gap in the axle where the staked part is hammered into. Thus the nut can rotate a couple of degrees back and forth. It just seems wrong that it should be so loose?
(https://i.postimg.cc/zLB3tMJB/C7691-B2-E-1839-4-DC4-BF32-0-FB1-A8-D7-D242.jpg) (https://postimg.cc/zLB3tMJB)

Title: Re: Wheel nut torque
Post by: Guldbergdk on September 17, 2020, 12:45:56 PM

Anyone tried to change the front bearing and had to refit the wheel nut?

Title: Re: Wheel nut torque
Post by: sistemgeriyukleme on September 29, 2020, 12:34:39 PM

hope this helps