Club126UK
Fiat 126 Chat => Tuning & Customising 126 Models => Topic started by: Colin campbell on December 31, 2017, 10:18:02 PM
-
I’ve got 1990 bis and am putting the 1.1 seicento engine in . Car will be gutted and full cage fitted, and new trailing arms put in rear to avoid camber change . Will be posting photo updates as I go ..!
-
I’ve got 1990 bis and am putting the 1.1 seicento engine in . Car will be gutted and full cage fitted, and new trailing arms put in rear to avoid camber change . Will be posting photo updates as I go ..!
Hi Colin,
That sounds like a really cool project keep me updated!
With Regards
Luca
-
Ok, roll cage in this weekend , gearbox rebuilt with new bearings and close ratio gear kit . New bushes to be made for clutch release arm and the engine and box are ready to go in . Got photos but can’t resize them from my phone .. can I only resize them from a laptop .?
-
im looking at engine swaps on the BIS too , any info would be much appreciated - also
where did you get the cage ?
-
Pictures now on : fiat 126 uk Facebook page ... easier to add them on there ..!
-
Fire engine is the best engine to swap for . I’ve taken 40mm off the bottom of the sump and shortened the oil pick up on the pump , few tweaks to make the adapter plate fit properly , flywheel skimmed both sides to fit .
You need to be able to fabricate a few parts yourself , all the major parts are available off the shelf . I’m just fitting 2 1/4 “ coilover’s on the rear of mine . I’m also making an alloy inlet manifold for twin 40 Weber’s .
My mate bent the tubes up for the cage and I fitted it in , he’s in worthing and could make one for you .? I may be able to get the main hoop and front side bars bent up for you if you can weld .??