Recent Posts

Pages: 1 [2] 3 4 ... 10
11
Fiat 126 Mechanical Problem Solving / Re: Bis starter motor
« Last post by mintex on November 09, 2025, 01:56:25 AM »
So turns out its not my starter motor  :$
My fault as i should have checked but in my defence i have been having starter problems for a bit with intermittent turning over that i thought was a starter problem but ive installed the new reconditioned one that give me the same problem only to test and find out its the main power to the starter thats the problem  :$

Is there a main fuse to the starter before i just run i new cable to it, ive looked  but didn't see one, cheers
12
Fiat 126 Mechanical Problem Solving / Re: Bis starter motor
« Last post by mintex on November 03, 2025, 06:48:32 PM »
Cheers just bought it 👍
13
Fiat 126 Mechanical Problem Solving / Re: Bis starter motor
« Last post by ChrisRLewis on November 03, 2025, 12:46:46 PM »
not sure if this is the correct starter motor for your 126?
https://tinyurl.com/2kszxyaf
14
Fiat 126 Mechanical Problem Solving / Re: Bis starter motor
« Last post by mintex on November 03, 2025, 11:02:45 AM »
Cheers, yes maybe, i will look for a local one, .must still be some about in this throw away age we seem to be in nowdays lol.
15
Fiat 126 Mechanical Problem Solving / Re: Bis starter motor
« Last post by ChrisRLewis on November 02, 2025, 10:35:01 AM »
Perhaps a company that reconditions starter motors can sort this out?
16
Fiat 126 Mechanical Problem Solving / Re: Bis starter motor
« Last post by mintex on November 02, 2025, 12:03:30 AM »
Ive looked on most of the normal 126 parts websites and they all say not in stock , not sure where to go next now  :(
17
Fiat 126 Mechanical Problem Solving / Bis starter motor
« Last post by mintex on November 01, 2025, 12:01:28 AM »
Hi all , anyone know where i can order a new starter motor or if its shared with another car i can search for please.  Ta.
18
Fiat 126 Mechanical Problem Solving / Re: Water pump shaft
« Last post by andyzeetec on October 08, 2025, 12:46:02 PM »
Proper job that ;)

Its a shame all the pictures have disappeared?
19
Wanted: / RH Door with quarter light
« Last post by desmos on October 02, 2025, 11:30:54 AM »
After a right hand door for my '81. Twin swage line and a quarter light...
20
Hi Chris,
I unscrewed the main jet nozzle from the bowl, cleaned it out. I set the float height and the engine runs fine now, however I'm still getting a small amount of fuel leaking into the plastic base (directly below the carb). Looks like it's coming through the gasket between the carb cover and main part of the carb.
Do you have any suggestions about how to stop that leak?
Pages: 1 [2] 3 4 ... 10