Fiat 126 Chat > Tuning & Customising 126 Models

Side lights.

(1/2) > >>

Magic:
Hi Guys

I purchased some led sidelights to replace the standard ones.

They are T4W as per original but do not want to work, Is there anything I can do / change to allow them to work ?

TIA

Robbie

Da Londo:
I think you need an additional resistor for each led for them to work.

Sent from my POT-LX1T using Tapatalk

Rusty's Uncle:
If you are talking sidelights then they should work. If you mean indicators then you need to fit an electronic flasher unit  :)

danthemanic:
I had a similar situation with an old motorbike.  LEDs must have polarity applied the same way, whereas normal bulbs can accept polarity either way.  Wiring a small bridge rectifier before each bulb may solve this. Or as Rusty's Uncle says, he probably has a ton more experience than I do.

Pete126:
As Dan said, If you have spade connectors on the bulb holder you can just swap them round if not just cut the wires and use a terminal block to connect them.

Navigation

[0] Message Index

[#] Next page