Author Topic: Wanted: 126 bis accelerator cable bracket  (Read 162 times)

0 Members and 1 Guest are viewing this topic.

michaelodonnell500

  • Super Member
  • ***
  • Posts: 751
  • Karma: 7
Wanted: 126 bis accelerator cable bracket
« on: September 02, 2020, 06:51:03 PM »
Hi, does anyone have an accelerator cable bracket for a bis,?
It is the bracket near the carb where the cable outer clips on to.
Thanks,

Michael
Rust does not discriminate

Guldbergdk

  • Subscribers
  • Member
  • ****
  • Posts: 72
  • Karma: 1
  • Location: Denmark
Re: Wanted: 126 bis accelerator cable bracket
« Reply #1 on: September 02, 2020, 09:39:07 PM »
I can take some measurements if you want to make one. Shouldnt be that difficult

michaelodonnell500

  • Super Member
  • ***
  • Posts: 751
  • Karma: 7
Re: Wanted: 126 bis accelerator cable bracket
« Reply #2 on: September 03, 2020, 10:03:32 AM »
That would be great, thank you!
Am I right in thinking it mounts onto the cylinder head where the exhaust is bolted on?

I think the cable in my car is sitting at the right height vertically, but I don't know how long the bracket should be, that would be a big help.

Thanks,

Michael
Rust does not discriminate

ChrisRLewis

  • Administrator
  • Super Member
  • *****
  • Posts: 1659
  • Karma: 22
    • Club126uk
  • Location: Swansea, UK
Re: Wanted: 126 bis accelerator cable bracket
« Reply #3 on: September 03, 2020, 10:12:26 AM »
Michael what make carburettor do you have fitted to your Bis? There maybe variations in the design of the bracket for different carbs?

michaelodonnell500

  • Super Member
  • ***
  • Posts: 751
  • Karma: 7
Re: Wanted: 126 bis accelerator cable bracket
« Reply #4 on: September 03, 2020, 11:12:10 AM »
Thanks Guys, I found the bracket!
It was in the front luggage compartment!

I picked up the car at the weekend, a number of parts have been stripped off of it. I'm not familiar with the bis engine so I didn't recognise the bracket at first, but the technical download section helped me to identify it.

Incidentally its a weber 30 DGF. The top thread for the airbox mount is badly damaged, but I'm awaiting a couple of scrap/spares 30DGF bis carbs, so I should be able to make it right.

I will have to start a restoration page on the car. Lots of rust, but very low mileage.....
Rust does not discriminate

Guldbergdk

  • Subscribers
  • Member
  • ****
  • Posts: 72
  • Karma: 1
  • Location: Denmark
Re: Wanted: 126 bis accelerator cable bracket
« Reply #5 on: September 03, 2020, 12:12:45 PM »
Great:) Yes, it bolts on on top of the exhaust outlet.

I just did a complete tear down and rebuild of my BIS engine, so I might be able to answer your questions. You could skip the airbox and just put a filter on top of the carb. Thats what I did

 

SimplePortal 2.3.6 © 2008-2014, SimplePortal