Author Topic: 126 Bis gearbox mounts. Dimensions needed.  (Read 1059 times)

0 Members and 1 Guest are viewing this topic.

michaelodonnell500

  • Super Member
  • ***
  • Posts: 758
  • Karma: 7
126 Bis gearbox mounts. Dimensions needed.
« on: September 24, 2019, 10:18:12 AM »
Following up on a few posts from some other forum members here, does anyone have a gearbox mount and can measure the following:
the diameter of the bush (the pressed in metal ring surround the rubber)
The thickness of the bush.

There must be something out there similar!
Rust does not discriminate

126blackbird

  • Super Member
  • ***
  • Posts: 173
  • Karma: 5
  • Location: Maldon Essex
Re: 126 Bis gearbox mounts. Dimensions needed.
« Reply #1 on: September 25, 2019, 10:46:42 AM »
There was a post on one of the forum's that said a BMW bush will fit, the hole for the gearbox stud is a little bit larger so you have to modify this or fit a sleeve, I did buy a pair of these but as yet not tried to fit them. I'm not at home for a couple of day but will see if I can find the part number when I return